This piece is used mainly for racers. When you need to remove and replace your wheels fast, this is the answer. Screw one end into the hole in your hub that the lug nuts usually go into. Then, when you slide your wheel over the stud, quickly and easily tighten the nuts and you're ready to go. Pictured here with the required Nuts.

These are the Nuts required if you're using the Quick Safe Wheel Studs from H&R. Makes pulling your wheels off and on much easier. These are both 12x1.5mm thread pitch - standard for BMW's and many other European vehicles.

H&R Makes the highest quality wheel bolts available. These can be used as replacements for factory pieces, or in conjunction with their Wheel Spacers. We recommend these over studs for street cars as they function the same as factory wheel bolts. They fit under any wheel bolt covers that you may have.

Please note: the thread length is measured from the taper to the end of the bolt, so only the tapered portion is measured. Please be sure of your thread pitch!