If you want to install a racing shell and need to get the seat as low as possible, this is perhaps the best way to do it. Bolts directly to the Factory points in your car, it will require no modification to your chassis. Features many threaded holes to help you get your seat positioned exactly where you want it.
If you're not looking to bolt your seat down in a fixed location, you can also mount some sliders to these and then bolt your seat to the sliders. They usually work with both narrow and wide seats. If you are planning on using a Cobra GT width seat with Cobra Side Plates, you should let us know, so we can order a special bolt pattern to make it easier to get the seat in the right location.
These brackets are made From 3/4" 6061-T6 Billet Aluminum and come with the hardware necessary to bolt a set of side plates down to them.
| Part Number | Chassis | Finish | Price |
|---|
These Strips make it extremely easy to bolt in aftermarket seats into a 996. They bolt to the floor of your 996, and then to the sliders.
| Part Number | Price |
|---|
These Seat Adapters from The Racers' Group allow you to mount recaro sliders (non-tabbed version) to the factory floor mount locations. This is an economical way to mount a Recaro seat in your car.
This bracket mounts to the floor, then the slider mounts to the top of this bracket. You'll mount the seat to the top of the slider. It is virtually impossible to get a Recaro seat any lower than with these brackets.
Works for All Porsches after the 996 except the Cayenne. (996, Boxster, 997, Cayman)
Compare to the Brey Krause version of the same product.
| Part Number | Price |
|---|