Made of Stainless Steel, this harness guide bar will give you something to route your shoulderbelts over before mounting them to the rear seat anchors. This will help alleviate the steep angle needed to put shoulder harnesses in a 911.

This bar is designed as a guide bar only, and is Not designed to take the full load of shoulder belts! You must feed your shoulder belts over this bar, and then attach them to the factory rear points.

Attaches to B Pillars. Fits all 911 Coupes from 1974-1998 and is designed so that tall drivers will not lose any seat travel.

This Stainless Steel Harnes Guide bar is designed to bolt into the B Pillars of your 944, 924, or 968. It will give you a bar to feed your shoulder harnesses through to keep them in the right horziontal position as well as to fix the steep angle present when shoulder belts are installed in these cars.

This bar is designed as a guide bar only, and is Not designed to take the full load of shoulder belts! You must feed your shoulder belts over this bar, and then attach them to the factory rear points.

Will not rob tall drivers of any seat adjustment.